AllStarLink Standard Commands
This section contains the suggested prefix digits, mandatory command codes, and suggested command codes for AllstarLink.
Mandatory Command Codes
These are the mandatory command codes which all AllStarLink nodes must support to provide command code consistency to the users.
| Command | Description |
|---|---|
*1<node> |
Disconnect Link |
*2<node> |
Connect link in monitor mode |
*3<node> |
Connect link in transceive mode |
*4<node> |
Enter command mode on a remote node |
*70 |
Local connection status |
*99 |
DTMF Phone Key (Assert PTT from Phone Portal) |
Notes:
<node>is an AllStarLink node number- Node number zero (
0) is shorthand for the last node operated on by a previous command - Monitor mode means listen to a node, but do not send any audio to it
- Command mode means send all received DTMF digits to the node number specified (bypassing the local command decoder). Send # to exit command mode, and restore local command decoding.
Prefix Digit Suggestions
These are the suggested DTMF command prefixes (including the mandatory 1-4).
| Prefix | Description |
|---|---|
*1 |
Disconnect from link |
*2 |
Connect to node in monitor (receive only) mode |
*3 |
Connect to node in transceive mode |
*4 |
Enter remote command mode |
*5 |
User-defined macros |
*6 |
User defined functions, such as autopatch |
*7 |
Connection status / other functions |
*8 |
User defined functions |
*9 |
User defined functions |
*0 |
User defined functions |
*A |
User defined functions |
*B |
User defined functions |
*C |
User defined functions |
*D |
User defined functions |
Optional Command Codes
These are suggested, but are typically configured by default on ASL3 nodes.
| Command | Description |
|---|---|
*80 |
Force system ID |
*81 |
Say system time |
*980 |
Say app_rpt software version |
*75 |
Link connect (local monitor only) |
*72 |
Last active node (system-wide) |
*73 |
System-wide connection status |
*71 |
Disconnect all links (macro) |
*74 |
Reconnect all links (macro) |
Complete List of AllStarLink Commands
The default AllStarLink DTMF commands are well commented in the configuration file /etc/asterisk/rpt.conf. These may be changed if you or someone else edited the file, so take a look at the actual file on your node to be sure.
All of the possible commands are documented at the top of the source. You don't need to be a C programmer to read the comments.